.410 shooters.
-
- Posts: 23
- Joined: March 20th, 2015, 7:37 am
- Location: West Central Mo.
.410 shooters.
You guys shooting .410s. Are you having screw in chokes installed in your guns or are you shooting the factory Full chokes??
If you are having the gun threaded who is doing your choke work?
If a factory screw in choke gun what chokes are you using?
If you are having the gun threaded who is doing your choke work?
If a factory screw in choke gun what chokes are you using?
Re: .410 shooters.
I sent my mossberg to sumtoy customs and him install chokes.
Re: .410 shooters.
Check with William at SumToy Customs. He has done a number of 410's.
Re: .410 shooters.
I gave jebs a try. They did a great job threading my barrel but their choke was too tight (.381) for my setup (browning invector/ Winchester/ Mossberg threading). Pattern was blown. I’m giving compnchoke a try. They come highly recommended. So we will see.
Shooting Apex 27/32 9.5s
Shooting Apex 27/32 9.5s
Re: .410 shooters.
I shot factory full for a few years and it averaged 100 in the 10 at 40. Sumtoy choked it and it improved patterns over 50%. Gil
Re: .410 shooters.
I have had a couple barrels cut and choked by Mike Orlen. He is exceptional at what he does. Here is a link to his contact info. I am still shooting my factory full in my Yildiz single. With #9.5s, my patterns are good enough to take a turkey, will hunt it for a year or two before I decide if I want to choke it.
http://users.dls.net/~rdouglas/MikeOrlen.pdf
http://users.dls.net/~rdouglas/MikeOrlen.pdf
-
- Posts: 364
- Joined: April 22nd, 2012, 3:19 pm
Re: .410 shooters.
What kind of numbers at 40 did you get with the Jebs choke? Just curious.batsonbe wrote: ↑May 17th, 2018, 11:13 pm I gave jebs a try. They did a great job threading my barrel but their choke was too tight (.381) for my setup (browning invector/ Winchester/ Mossberg threading). Pattern was blown. I’m giving compnchoke a try. They come highly recommended. So we will see.
Shooting Apex 27/32 9.5s
Re: .410 shooters.
Factory full - 10” 124 20” 129
Jebs x full - 10” 128 20 121
Dirty barrel wasn’t even worth counting
Jebs x full - 10” 128 20 121
Dirty barrel wasn’t even worth counting
-
- Posts: 364
- Joined: April 22nd, 2012, 3:19 pm
Re: .410 shooters.
.385
I asked if they could make a .383 and a .387 as well
I asked if they could make a .383 and a .387 as well
Re: .410 shooters.
Re: .410 shooters.
My plan is to work on keeping the parallel section straight. I am not sure what the hone is going to want to do. This is strictly experimentation. I am guessing it will follow the existing conture.
Re: .410 shooters.
What exact tool are you using to open the choke up?