Gobbler Nation

Well with the warm weather I finally got to put some TSS threw some paper

Here a few pictures,I was lucky enough to take since the over pressure load didn't take me out...Should work for the hills and hollars and the occasional off the limb shot


Shot a IC 555 at 30&40 then a IC 562 at 40








Sent from somewhere deep in West By God

That's smoking buddy.


Sent from my iPhone using Tapatalk

Leaves burnt orange holes in the paper. Yep, first indicator of a high pressure load.

guesswho wrote:Leaves burnt orange holes in the paper. Yep, first indicator of a high pressure load.

Yep, orange hole = high p2

Be careful son. Them HP loads might knock off heads on both ends.

Simply brutal! Congrats.

Does anybody else that is shooting an M2 with an IC choke have a gap between the end of the barrel and the choke? I expect a little gap to show that the choke is seated, but the gap on mine is right at an 1/8" and it just looks like crap.

Deom wrote:Does anybody else that is shooting an M2 with an IC choke have a gap between the end of the barrel and the choke? I expect a little gap to show that the choke is seated, but the gap on mine is right at an 1/8" and it just looks like crap.

I think mine fit flush. I will screw it in a little later today and get you a pic.

Deom wrote:Does anybody else that is shooting an M2 with an IC choke have a gap between the end of the barrel and the choke? I expect a little gap to show that the choke is seated, but the gap on mine is right at an 1/8" and it just looks like crap.

Tiny gap in mine. Almost unnoticed

Dr Juice wrote:Simply brutal! Congrats.

brutal on turkeys too!!!!

Deom wrote:Does anybody else that is shooting an M2 with an IC choke have a gap between the end of the barrel and the choke? I expect a little gap to show that the choke is seated, but the gap on mine is right at an 1/8" and it just looks like crap.

Yep. I've noticed it on my M2 and also a browning maxus, and browning gold.

Small slight gap on mine also with IC choke . Wont hurt a thing as long as you got it screwed all the way in !

Deom wrote:Does anybody else that is shooting an M2 with an IC choke have a gap between the end of the barrel and the choke? I expect a little gap to show that the choke is seated, but the gap on mine is right at an 1/8" and it just looks like crap.

Yep small gap. As long as it mates up inside you're all good

If there is a slight gap double up on the thread grease esp. at the bottom of the tube which will mitigate the potential erosion/corrosion caused by the hot gasses.

The gap is not where the choke mates with the bore or you would have a yuge problem. It's where the choke seats on the end of the barrel

This

Turkinator wrote:This

Yeah mine is worse than that. The packaging says gaps are allowed up to 1/32. Mine is right at an 1/8". I wish I knew how to post a dang picture on here.

Thank God your ok from shooting those,......but good patterns.....

What load were you shooting that was over pressured? What was the psi?

that is not a problem if a small gap.(not 1/8) That just lets you know they are bottom out on inside of the barrel. Ours do the same.